Everything below concerns aspartimide. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Updated 2026-06-05. Numbers and descriptions here follow the published literature rather than marketing material.
Epitalon is a synthetic tetrapeptide with the amino acid sequence alanine-glutamate-aspartate-glycine, abbreviated Ala-Glu-Asp-Gly or AEDG. It was developed by the Russian researcher Vladimir Khavinson and colleagues during work on peptide bioregulators derived from the pineal gland. The compound is short enough to be produced by standard solid-phase peptide synthesis and is typically handled as a lyophilized white powder. Its small size distinguishes it from larger pineal peptides such as epithalamin, a complex extract from which the tetrapeptide was conceptually derived.
The four residues give epitalon a molecular formula of C14H22N4O9 and a molecular weight near 390.35 daltons. The presence of two acidic residues, glutamate and aspartate, makes the free peptide strongly acidic, while the alanine and glycine ends provide neutral, nonpolar character. This combination produces a molecule with substantial water solubility. Because there are no cysteine, methionine, or tryptophan residues, the peptide lacks the most common oxidation-sensitive side chains, which simplifies handling compared with many longer peptides.
Identity and purity of epitalon samples are normally established by reversed-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres, combined with mass spectrometry. The mass spectrum confirms the expected molecular ion and can reveal truncated or oxidised by-products. Amino acid analysis after acid hydrolysis verifies that the four residues are present in the expected ratio. Certificates typically report a purity figure taken from chromatographic peak area, expressed as a percentage of total integrated signal.
Lyophilised epitalon is generally held at minus twenty degrees Celsius in a sealed container kept dry and dark. Cooler conditions are sometimes recommended for long-term archives. The solid takes up moisture readily enough that repeated opening of a vial introduces water, so dividing a batch into smaller portions before storage lowers degradation risk. Aqueous solutions are less durable than the dry powder and are usually prepared shortly before use, then kept cold and shielded from light to slow hydrolysis and oxidation.
Verification of research-grade material involves comparing a supplier chromatogram against an in-house reference, checking the observed mass against the calculated value, and where possible confirming residue order by tandem mass spectrometry or enzymatic peptide mapping. Purity claims should be read alongside the method used to obtain them, because detection wavelength and integration settings alter the result. Batch-specific data, rather than a generic grade statement, is the informative part of a certificate.
| Property | Value | Notes |
|---|---|---|
| Amino acid sequence | Ala-Glu-Asp-Gly | Tetrapeptide, often abbreviated AEDG |
| Molecular formula | C14H22N4O9 | Free peptide, unmodified termini |
| Molecular weight | ~390.35 Da | Calculated for the free acid form |
| Appearance | White to off-white powder | Typical lyophilized product form |
| Solubility class | Freely soluble in water | Two acidic residues dominate ionic character |
Epitalon is a synthetic tetrapeptide whose four residues are alanine, glutamate, aspartate and glycine, commonly abbreviated AEDG. Its molecular formula is C14H22N4O9 and its monoisotopic mass is near 390.35 daltons. The peptide carries two acidic side chains, so it is neutral to negatively charged in most aqueous buffers. Published reference summaries usually list it under both spellings, epitalon and epithalon, and treat the two names as the same material.
The compound is generally described as a synthetic analogue of a fragment isolated from a pineal gland extract. Researchers associated with the Saint Petersburg Institute of Bioregulation and Gerontology introduced it during the 1980s and 1990s while studying short peptides from animal tissue. The original extract, called epithalamin, is a heterogeneous mixture, whereas epitalon is a single defined sequence. That distinction matters because findings reported for the extract are not automatically findings about the pure tetrapeptide, and claims about broader biological effects remain a separate question from the chemical identity described here.
Verification of a sample usually begins with reversed-phase high-performance liquid chromatography, which resolves the peptide from truncated sequences and other impurities and expresses purity as a percentage of total peak area. Mass spectrometry by electrospray ionisation or matrix-assisted laser desorption supplies an independent check, because the measured mass can be compared against the theoretical value for AEDG. Amino acid analysis or tandem mass spectrometry sequencing can confirm residue order. Each of these methods answers a different question: a purity figure does not establish identity, and an identity match does not establish how much of the material is intact peptide.
The molecule is a short, linear, hydrophilic peptide that dissolves readily in water or aqueous buffer. Its principal chemical liabilities are hydrolytic rather than oxidative, since it contains no cysteine, methionine, or tryptophan residues. The aspartate–glycine step is a recognised site for aspartimide formation under mildly acidic or basic conditions, generating isoaspartate and succinimide-related products over time. Desiccated lyophilised powder held at −20 °C is comparatively stable, whereas dilute solutions degrade faster and are best frozen as single-use aliquots rather than thawed repeatedly.
The most frequently cited proposed action is induction of telomerase, the enzyme that adds repeat sequences to chromosome ends. Cell-culture work from the originating group reported higher telomerase reverse transcriptase expression and measurable telomere elongation in human somatic cells after exposure. How a four-residue peptide would reach nuclear gene regulation is not established, and no cell-surface receptor or uptake route has been identified. Additional reports describe changes in melatonin secretion, antioxidant enzyme activity and lipid peroxidation in aged animals, but these findings remain mechanistically unconnected to the telomerase observation.
Published evidence comes mainly from Russian-language journals and from a single research group, with small sample sizes and limited independent replication. A few laboratories outside that group have examined related peptides and reported weaker or absent telomerase effects, so the central claim is best described as contested rather than settled. Rodent studies report modest changes in some ageing markers and in survival, but designs vary and control conditions are often sparse. No large randomised trial in humans has been published, and long-term safety data in healthy populations are correspondingly thin.
Because epitalon has no pharmacopoeial monograph, quality assessment depends on supplier documentation and independent testing. Certificates of analysis typically report a purity figure from a single chromatographic run, a measured mass and sometimes an appearance description, but methods and acceptance criteria are not harmonised across vendors. Third-party laboratories can repeat identity and purity measurements, and mismatches between labelled and measured peptide content have been described for research peptides generally. What constitutes adequate identity confirmation for a molecule of this size stays an open question, since mass agreement alone does not separate closely related sequences.
Identity testing for epitalon relies on reversed-phase high-performance liquid chromatography for purity and mass spectrometry for mass confirmation. Because the sequence contains no tryptophan or tyrosine, ultraviolet detection at 280 nanometres is insensitive, so chromatographic methods usually monitor absorbance near 214 nanometres, where the peptide backbone absorbs. Electrospray ionisation or matrix-assisted laser desorption/ionisation then checks the intact mass against the expected value near 390 daltons. Peptide mapping or amino acid analysis after acid hydrolysis can supplement these measurements, although such confirmatory work is seldom reported on commercial certificates of analysis.
Stability of the tetrapeptide follows ordinary peptide chemistry rather than any unusual structural feature. The aspartate-glycine pair is prone to aspartimide formation under mildly basic or neutral conditions, and deamidation can follow, altering both mass and chromatographic retention. Dry lyophilised powder kept at or below minus twenty degrees Celsius is the usual handling recommendation, with repeated freeze-thaw cycles avoided. Once dissolved in neutral aqueous buffer, degradation proceeds over days to weeks depending on pH and temperature, while acidic conditions generally slow the aspartimide route. A formal stability-indicating study has not been published in the indexed literature.
When SO2−4 is assimilated by organisms, it is reduced and converted to organic sulfur, which is an essential component of proteins. However, the biosphere does not act as a major sink for sulfur, instead the majority of sulfur is found in seawater or sedimentary rocks including: pyrite rich shales, evaporite rocks (anhydrite and baryte), and calcium and magnesium carbonates (i.e. carbonate-associated sulfate). The amount of sulfate in the oceans is controlled by three major processes:
Most clinical antibiotics were found during the "golden age of antibiotics" (1940s–1960s). Actinomycin was the first antibiotic isolated from Streptomyces in 1940, followed by streptomycin three years later. Antibiotics from Streptomyces isolates (including various aminoglycosides) would go on to comprise over two-thirds of all marketed antibiotics. Streptomyces-derived antibiotics include: Clavulanic acid (Streptomyces clavuligerus) is used in combination with some antibiotics (such as amoxicillin) to weaken bacterial-resistance. Novel anti-infectives being developed include the guadinomines (from Streptomyces sp. K01-0509), inhibitors of the type III secretion system. Non-Streptomyces actinomycetes, filamentous fungi, and non-filamentous bacteria, have also yielded important antibiotics. Nystatin (Streptomyces noursei), amphotericin B (Streptomyces nodosus), ossamycin (Streptomyces hygroscopicus), and natamycin (Streptomyces natalensis) are antifungals isolated from Streptomyces.
An analytical ultracentrifuge has a light source and optical detectors. To allow the light to pass through the analyte during the ultracentrifuge run, specialized cells are required which have to meet high optical standards as well as to resist the centrifugal forces. Each cell consists of a housing, two windows made from optically pure quartz glass, and a centrepiece with one or two sectors and filling holes for the sector(s), closed with a screw plug in the housing. These cell are placed into a rotor cavity with a continuous bore, with a collar at the bottom to retain the cell. By applying specific equipment and adapting measurement parameters several types of experiments can be performed. Most common AUC experiments are sedimentation velocity and sedimentation equilibrium experiments.
Sources: en.wikipedia.org
Chattopadhyay's contributions in membrane and receptor biology and biophysics have been recognized by several awards and prizes. These include The World Academy of Sciences (TWAS) Prize, Shanti Swarup Bhatnagar Award, Ranbaxy Research Award, Prof. G.N. Ramachandran Gold Medal, SERB Distinguished Fellowship, Prof. G.N. Ramachandran 60th Birthday Medal and J.C. Bose Fellowship. He is an elected Fellow of The World Academy of Sciences, Royal Society of Biology, Royal Society of Chemistry, and all the Indian Academies of Science. Fellow, The World Academy of Sciences (2017) Fellow, The Royal Society of Biology (2017) Fellow, The Royal Society of Chemistry (2013) Fellow, Indian National Science Academy (2005) Fellow, Indian Academy of Sciences (1999) Fellow, The National Academy of Sciences, India (1998) Fellow, West Bengal Academy of Science & Technology (2010) Fellow, Andhra Pradesh Akademi of Sciences (2003) Fellow, Telangana Academy of Sciences (2015) Google Scholar
In order for a protonated acid to lose a proton, the pH of the system must rise above the pKa of the acid. The decreased concentration of H+ in that basic solution shifts the equilibrium towards the conjugate base form (the deprotonated form of the acid). In lower-pH (more acidic) solutions, there is a high enough H+ concentration in the solution to cause the acid to remain in its protonated form. Solutions of weak acids and salts of their conjugate bases form buffer solutions. To determine the concentration of an acid in an aqueous solution, an acid–base titration is commonly performed. A strong base solution with a known concentration, usually NaOH or KOH, is added to neutralize the acid solution according to the color change of the indicator with the amount of base added. The titration curve of an acid titrated by a base has two axes, with the base volume on the x-axis and the solution's pH value on the y-axis. The pH of the solution always goes up as the base is added to the solution.
Pituitary adenylate cyclase-activating polypeptide type I receptor also known as PAC1, is a protein that in humans is encoded by the ADCYAP1R1 gene. This receptor binds pituitary adenylate cyclase activating peptide. PAC1 is a membrane-associated protein and shares significant homology with members of the G-protein coupled class B glucagon/secretin receptor family. This receptor mediates diverse biological actions of adenylate cyclase activating polypeptide 1 and is positively coupled to adenylate cyclase. Alternative splicing of two exons of this gene generates four major splice variants, but their full-length nature has not been determined. PAC1 is expressed in the adrenal medulla, pancreatic acini, uterus, myenteric plexus and brain. It is also expressed in the trigeminal, otic and superior cervical ganglia (prejunctional) and cerebral arteries (postjunctional).
Sources: en.wikipedia.org
Epitalon is a synthetic tetrapeptide composed of four amino acids: alanine, glutamate, aspartate, and glycine. It is written as Ala-Glu-Asp-Gly. The free peptide has a molecular weight of about 390 daltons and is normally supplied as a lyophilized powder.
No. Epitalon is chemically synthesized, not extracted. It was designed as a short synthetic fragment conceptually related to larger pineal peptides studied in the same research tradition, particularly the extract known as epithalamin. The two are distinct materials with different compositions.
The term bioregulator is used in this research tradition for short peptides proposed to influence gene expression or cell function. Epitalon is grouped with other synthetic short peptides under this label. The term reflects a proposed mechanism rather than an established drug classification.
The usual approach is reversed-phase HPLC with ultraviolet detection, reported as a percentage of total peak area. Mass spectrometry is used alongside chromatography to confirm identity rather than purity alone.