Reversed-phase HPLC is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Updated 2026-05-26. Numbers and descriptions here follow the published literature rather than marketing material.
Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and its calculated monoisotopic mass is approximately 390.35 daltons. The compound does not occur naturally as a free peptide; it is produced by solid-phase peptide synthesis. Because it contains two acidic residues and no basic residues, the neutral form carries a net negative charge at physiological pH. This charge profile influences how the peptide behaves in solution and during chromatographic analysis.
Laboratory-grade epitalon is typically supplied as a lyophilized powder. Purity is commonly assessed with reverse-phase high-performance liquid chromatography, often paired with mass spectrometry to confirm molecular identity. Amino acid analysis and peptide mapping can provide additional confirmation of sequence. Certificates of analysis for research materials frequently report purity above 95 percent, although the methods behind such figures vary between suppliers. The absence of a pharmacopeial monograph means that no single standardized assay defines the compound, so reported results depend on the analytical protocol chosen.
Storage recommendations center on limiting moisture, heat, and light. The dry powder is generally kept at minus 20 degrees Celsius, and some suppliers recommend minus 80 degrees for long-term archival. Once dissolved, solutions are usually aliquoted and frozen to avoid repeated freeze-thaw cycles, which can promote aggregation or degradation. Aqueous stability depends on pH and concentration, and buffered saline is often preferred over plain water for biological work. Stability data specific to epitalon remain limited, so general peptide-handling practices are applied by analogy rather than from product-specific validation.
Identity testing for epitalon relies on reversed-phase high-performance liquid chromatography for purity and mass spectrometry for mass confirmation. Because the sequence contains no tryptophan or tyrosine, ultraviolet detection at 280 nanometres is insensitive, so chromatographic methods usually monitor absorbance near 214 nanometres, where the peptide backbone absorbs. Electrospray ionisation or matrix-assisted laser desorption/ionisation then checks the intact mass against the expected value near 390 daltons. Peptide mapping or amino acid analysis after acid hydrolysis can supplement these measurements, although such confirmatory work is seldom reported on commercial certificates of analysis.
Stability of the tetrapeptide follows ordinary peptide chemistry rather than any unusual structural feature. The aspartate-glycine pair is prone to aspartimide formation under mildly basic or neutral conditions, and deamidation can follow, altering both mass and chromatographic retention. Dry lyophilised powder kept at or below minus twenty degrees Celsius is the usual handling recommendation, with repeated freeze-thaw cycles avoided. Once dissolved in neutral aqueous buffer, degradation proceeds over days to weeks depending on pH and temperature, while acidic conditions generally slow the aspartimide route. A formal stability-indicating study has not been published in the indexed literature.
Because epitalon has no pharmacopoeial monograph, quality assessment depends on supplier documentation and independent testing. Certificates of analysis typically report a purity figure from a single chromatographic run, a measured mass and sometimes an appearance description, but methods and acceptance criteria are not harmonised across vendors. Third-party laboratories can repeat identity and purity measurements, and mismatches between labelled and measured peptide content have been described for research peptides generally. What constitutes adequate identity confirmation for a molecule of this size stays an open question, since mass agreement alone does not separate closely related sequences.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C14H22N4O9 | Free acid form of the tetrapeptide |
| Molecular mass | About 390.35 Da | Calculated monoisotopic value |
| Appearance | White to off-white powder | Typical lyophilized presentation |
| Solubility | Soluble in water | Also dissolves in buffered saline |
| Storage temperature | Minus 20 degrees Celsius | Dry, dark conditions; avoid repeated thawing |
Epitalon is the common name for a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, usually abbreviated AEDG. All four residues are proteinogenic amino acids, and the free peptide has a calculated mass near 390 grams per mole. Because the chain is short and carries no modifications, it is assembled readily by solid-phase synthesis and is distributed mainly as a freeze-dried solid for laboratory work. Catalogue listings use the spellings epitalon, epithalone, and simply AEDG, and the three refer to the same sequence.
The compound is generally presented as a synthetic fragment of epithalamin, a pineal gland extract investigated in the former Soviet Union from the 1970s onward. Vladimir Khavinson and colleagues in Saint Petersburg developed short peptides modelled on such extracts, and epitalon became the most widely cited of those sequences. Most primary reports appeared in Russian-language journals or in proceedings with limited international circulation. Independent replication in laboratories outside that network remains sparse, and much repeated secondary material traces back to a small number of originating groups.
The molecule is a short, linear, hydrophilic peptide that dissolves readily in water or aqueous buffer. Its principal chemical liabilities are hydrolytic rather than oxidative, since it contains no cysteine, methionine, or tryptophan residues. The aspartate–glycine step is a recognised site for aspartimide formation under mildly acidic or basic conditions, generating isoaspartate and succinimide-related products over time. Desiccated lyophilised powder held at −20 °C is comparatively stable, whereas dilute solutions degrade faster and are best frozen as single-use aliquots rather than thawed repeatedly.
No pharmacopoeial monograph exists for this peptide, so quality rests on the supplier's internal specifications and on whatever independent testing a purchaser arranges. Certificates of analysis differ widely in which tests they report and in the limits applied. The counter-ion introduced during purification, commonly acetate or trifluoroacetate, changes the net peptide content of a given mass of powder, so two samples of equal weight may not contain equal amounts of the active sequence. Third-party laboratories can verify purity, identity, residual solvents, and counter-ion content for a fee, which makes documentation more informative than labelling.
*fine chemicals merchant market size, growth potential Examples of applications in eight areas, ranging from adhesives to specialty polymers, are listed in Table 8. Overall, the attractiveness of the fine chemical industry is smaller than the life science industry. The total market, expressed in finished product sales, amounts to $150–200 billion, or about one fourth of the pharma market. The embedded fine chemicals account for an estimated $15 billion. Further disadvantages are the backward integration of the big players, e.g. Akzo-Nobel, Netherlands; Ajinomoto, Japan; Danone, France; Everlight Chemical Industrial Corp., Taiwan; Evonik-Degussa, Germany; Givaudan and Nestlé, Switzerland, Novozymes, Denmark, and Procter & Gamble, and Unilever USA. Innovation is based on new formulations of existing products, rather than the development of new fine chemicals. It is most likely to happen in application areas unrelated to human health, where NCEs are subject to very extensive testing.
=== Dextranomer in sodium hyaluronate === This is a newer material which became more popular after 2011. It is marketed as NASHA Dx, Zuidex, or Solesta. As of 2022, NASHA Dx is the only material approved in the US by the U.S. Food and Drug Administration (FDA). This material is composed of crosslinked dextranomer (dextran) microspheres and non-animal stabilized sodium hyaluronate (NASHA) in phosphate-buffered 0.9% sodium chloride solution. The particles are 120 μm in diameter. The material is non-allergenic, non-immunogenic and non-migratory. After injection, the hyaluronic acid is degraded, and soft tissue fibrosis forms with ingrowth of fibroblasts, inflammatory cells, blood vessels and collagen. This means that even though the particles undergo degradation, the bulking effects may persist. There are several publications which report the use of this material. They used submucosal injection site via the transmucosal route. Uncertainty about indications, cost, and durability of the material in the long term stopped widespread adoption of this material.
In most people with Alport syndrome (about 85%), the condition is inherited in an X-linked pattern, due to mutations in the COL4A5 gene. A condition is considered X-linked if the gene involved in the disorder is located on the X chromosome. In males, who have only one X chromosome, one altered copy of the COL4A5 gene is sufficient to cause severe Alport syndrome, explaining why most affected males eventually develop kidney failure. In females, who have two X chromosomes, a mutation in one copy of the COL4A5 gene usually results in blood in the urine, but most affected females do not develop kidney failure. Alport syndrome can also be inherited in an autosomal recessive pattern if both copies of the COL4A3 or COL4A4 gene, located on chromosome 2, have been mutated. Most often, the parents of a child with an autosomal recessive disorder are not affected but are carriers of one copy of the altered gene. Past descriptions of an autosomal dominant form are now usually categorized as other conditions. Notably, conditions associated with giant platelets and associated with mutations of MYH9 are no longer considered to be Alport variants. However apparent autosomal dominant transmission of disease associated with mutations in COL4A3 and COL4A4 does occur. Clinical utility gene card for: Alport syndrome.
Sources: en.wikipedia.org
=== Shooting of student at law school === Duterte stated at a rally in April 2016 that he shot a fellow student who had bullied him about his Visayan origin as well as other students of the same ethnicity, while at San Beda law college. He said, "But the truth is, I'm used to shooting people. When we were about to graduate from San Beda, I shot a person." Duterte said that he shot the student in a corridor at the college when the said student called him names again. He later told a reporter that the student survived, but refused to answer any further questions about the incident. However, in an interview aired on 24 Oras and published on the official GMA News Online website on April 22, 2016, retired labor arbiter Arthur Amansec said Duterte and Octavio Goco at that time were both playing with a gun as it was normal for students to bring guns to school in the seventies. Amansec is Duterte's former classmate in San Beda College who witnessed the incident. He added that "the bullet hit the school's wooden floor and was embedded there." Amansec emphasized that Duterte and Goco remained friends until Goco died in the United States years later.
==== Spanish Dual Language Program ==== The Spanish Dual Language Program gives equal emphasis to English and non-English language speakers. Students learn Spanish and English through content based instruction in selected core subjects with a cross cultural understanding for both native and non-native speakers. Students read, write, listen and speak in both languages, becoming bilingual, biliterate and bicultural.
M0: normal mandible M1: small mandible and glenoid fossa with short ramus M2: ramus short and abnormally shaped 2A: glenoid fossa in anatomical acceptable position 2B: Temperomandibular joint inferiorly (TMJ), medially, anteriorly displaced, with severely hypoplastic condyle M3: Complete absence of ramus, glenoid fossa, and TMJ Ear
Sources: en.wikipedia.org
Epitalon is a synthetic tetrapeptide built from four amino acids: alanine, glutamate, aspartate, and glycine. It is not extracted from a natural source but made in the laboratory by chemical synthesis. Its short length makes it relatively straightforward to produce at high purity.
No naturally occurring free form of the peptide has been described. The four-amino-acid sequence can appear as a fragment within larger proteins, but that is not the same as the intact compound being present as a circulating molecule. Materials used in research are synthetic.
Purity is usually checked by reverse-phase high-performance liquid chromatography, which separates the target peptide from related impurities. Mass spectrometry is commonly used alongside it to confirm molecular mass. Some suppliers also provide amino acid analysis for additional sequence confirmation.
The molecule lacks aromatic residues, so it absorbs weakly near 280 nanometres, the wavelength applied to many other peptides. The peptide bond absorbs strongly below 220 nanometres, making 214 nanometres a practical compromise. Gradient methods must therefore use mobile phases with low ultraviolet absorbance to keep the baseline clean.