Reversed-phase HPLC comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Updated 2026-04-14. Numbers and descriptions here follow the published literature rather than marketing material.
Epitalon is a synthetic four-amino-acid peptide with the sequence alanine-glutamate-aspartate-glycine, commonly abbreviated AEDG. Its molecular formula is C14H22N4O9, and its calculated molar mass is approximately 390.35 grams per mole. The compound is a short fragment related to a peptide fraction isolated from bovine pineal gland extracts, and it is normally supplied as a lyophilised powder intended for laboratory research. It is not a registered pharmaceutical product in most countries.
The peptide emerged from research carried out in Saint Petersburg from the late 1980s onward, where investigators searched for shorter active fragments of a pineal preparation known as epithalamin. The name epitalon was chosen to reflect that parent extract. Early reports described effects on neuroendocrine markers and on the lifespan of laboratory animals. Much of that work appeared in Russian-language journals, with English translations following later, which affects how readily the original protocols can be assessed by outside groups.
Verification of a sample usually begins with reversed-phase high-performance liquid chromatography, which resolves the peptide from truncated sequences and other impurities and expresses purity as a percentage of total peak area. Mass spectrometry by electrospray ionisation or matrix-assisted laser desorption supplies an independent check, because the measured mass can be compared against the theoretical value for AEDG. Amino acid analysis or tandem mass spectrometry sequencing can confirm residue order. Each of these methods answers a different question: a purity figure does not establish identity, and an identity match does not establish how much of the material is intact peptide.
The molecule is a short, linear, hydrophilic peptide that dissolves readily in water or aqueous buffer. Its principal chemical liabilities are hydrolytic rather than oxidative, since it contains no cysteine, methionine, or tryptophan residues. The aspartate–glycine step is a recognised site for aspartimide formation under mildly acidic or basic conditions, generating isoaspartate and succinimide-related products over time. Desiccated lyophilised powder held at −20 °C is comparatively stable, whereas dilute solutions degrade faster and are best frozen as single-use aliquots rather than thawed repeatedly.
No pharmacopoeial monograph exists for this peptide, so quality rests on the supplier's internal specifications and on whatever independent testing a purchaser arranges. Certificates of analysis differ widely in which tests they report and in the limits applied. The counter-ion introduced during purification, commonly acetate or trifluoroacetate, changes the net peptide content of a given mass of powder, so two samples of equal weight may not contain equal amounts of the active sequence. Third-party laboratories can verify purity, identity, residual solvents, and counter-ion content for a fee, which makes documentation more informative than labelling.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C14H22N4O9 | Derived from the four-residue sequence |
| Molar mass | About 390.35 g/mol | Free peptide, counter-ion not included |
| Appearance | White to off-white powder | Lyophilised solid from aqueous solution |
| Water solubility | Freely soluble | Short, polar peptide chain |
| Common synonyms | AEDG; epithalone | Catalogues use the names interchangeably |
Interest in epitalon is usually discussed within the broader field of short peptide bioregulators, a category that includes other synthetic di-, tri-, and tetrapeptides studied by the same research group. These compounds share a common rationale: that small fragments of tissue-derived proteins can retain biological activity and can be produced reproducibly. The category as a whole remains outside mainstream pharmacological consensus, and epitalon specifically has a limited presence in independent, non-Russian research literature, which shapes how its evidence base is described.
Epitalon is a synthetic tetrapeptide with the amino acid sequence alanine-glutamate-aspartate-glycine, abbreviated Ala-Glu-Asp-Gly or AEDG. It was developed by the Russian researcher Vladimir Khavinson and colleagues during work on peptide bioregulators derived from the pineal gland. The compound is short enough to be produced by standard solid-phase peptide synthesis and is typically handled as a lyophilized white powder. Its small size distinguishes it from larger pineal peptides such as epithalamin, a complex extract from which the tetrapeptide was conceptually derived.
Solubility is high in water, phosphate-buffered saline and normal saline, a pattern that follows from the two acidic residues in the chain. The peptide dissolves poorly in non-polar solvents such as hexane or chloroform. Stock solutions are often prepared in water first and then diluted into the buffer of interest. Because the molecule is small and hydrophilic, filtration through a low-protein-binding membrane is usually straightforward, and visible particulates are uncommon in freshly made solutions.
Identity and purity are established with reversed-phase high-performance liquid chromatography and mass spectrometry. The chromatogram shows the main peak and any truncated or oxidised by-products, while the mass spectrum confirms the expected 390 dalton mass. Amino acid analysis can corroborate composition when a sample's origin is uncertain. Counterion content, particularly residual trifluoroacetate from purification, is frequently reported alongside purity because it shifts the net mass of the solid.
Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and its calculated monoisotopic mass is approximately 390.35 daltons. The compound does not occur naturally as a free peptide; it is produced by solid-phase peptide synthesis. Because it contains two acidic residues and no basic residues, the neutral form carries a net negative charge at physiological pH. This charge profile influences how the peptide behaves in solution and during chromatographic analysis.
Laboratory-grade epitalon is typically supplied as a lyophilized powder. Purity is commonly assessed with reverse-phase high-performance liquid chromatography, often paired with mass spectrometry to confirm molecular identity. Amino acid analysis and peptide mapping can provide additional confirmation of sequence. Certificates of analysis for research materials frequently report purity above 95 percent, although the methods behind such figures vary between suppliers. The absence of a pharmacopeial monograph means that no single standardized assay defines the compound, so reported results depend on the analytical protocol chosen.
Storage recommendations center on limiting moisture, heat, and light. The dry powder is generally kept at minus 20 degrees Celsius, and some suppliers recommend minus 80 degrees for long-term archival. Once dissolved, solutions are usually aliquoted and frozen to avoid repeated freeze-thaw cycles, which can promote aggregation or degradation. Aqueous stability depends on pH and concentration, and buffered saline is often preferred over plain water for biological work. Stability data specific to epitalon remain limited, so general peptide-handling practices are applied by analogy rather than from product-specific validation.
Stability depends strongly on pH, temperature and the presence of oxygen and trace metals. Cleavage of the backbone proceeds faster under neutral to alkaline conditions, whereas acidic solutions tend to slow that reaction. The aspartate and glutamate side chains can undergo deamidation or imide formation over time, generating closely related impurities. Published stability data specific to epitalon are sparse, so the usable life of a given solution is best regarded as an open question that depends on buffer composition, concentration and storage temperature.
Identity and purity are usually assessed by reversed-phase high-performance liquid chromatography with ultraviolet detection, frequently near 214 nanometers where the peptide bond absorbs. Mass spectrometry, most often with electrospray ionization, confirms the observed molecular mass and helps separate the intact peptide from truncated or modified forms. Amino acid analysis or tandem mass spectrometry can establish residue order. Purity is commonly quoted as an area percentage, yet such values are method-dependent, and comparisons between laboratories require matching column, gradient and detection wavelength.
Laboratory handling begins with dissolution of the lyophilized powder in water or a suitable aqueous buffer. The dry solid is the more stable form, so stock solutions are generally prepared only when required and kept cold afterwards. Repeated freezing and thawing of a solution is avoided because it encourages aggregation and gradual loss of the intact chain. Diluents and containers are selected to limit adsorption of a short peptide onto plastic surfaces and to reduce microbial growth in aqueous preparations.
== Chemistry == Methylephedrine, also known as (1R,2S)-β-hydroxy-N,N-dimethyl-α-methyl-β-phenethylamine and as (1R,2S)-β-hydroxy-N,N-dimethylamphetamine, is a substituted phenethylamine and amphetamine derivative. It is the N-methylated derivative of ephedrine ((1R,2S)-β-hydroxy-N-methylamphetamine). A closely related compound and stereoisomer of methylephedrine is N-methylpseudoephedrine. Another related analogue is dimethylamphetamine (N,N-dimethylamphetamine), which is said to be a prodrug of methamphetamine and/or amphetamine. Other analogues include etafedrine (N-ethylephedrine) and cinnamedrine (N-cinnamylephedrine). The experimental log P of methylephedrine is 2.47 and its predicted log P ranges from 1.7 to 1.74. In organic chemistry, N-methylephedrine is used as a resolving agent and as a precursor to chiral supporting electrolytes, phase-transfer catalysts, and reducing agents.
== FSH analogues == Corifollitropin alfa Merck received approval on February 15, 2010, from the European Commission for ELONVA (corifollitropin alfa) a long lasting single injection fusion protein lacking LH activity. Only one injection is required for the first seven days, replacing the first seven daily injections of conventional FSH. Initial results demonstrates similar pregnancy rates as daily recombinant FSH injections.
== Rhabdomyolysis == Exertional rhabdomyolysis is an extreme and potentially deadly form of overtraining that leads to a breakdown of skeletal muscle which makes its way into the blood. Many molecules such as potassium, creatine kinase, phosphate, and myoglobin are released into circulation. Myoglobin is the protein that causes the lethal reaction in the body. Early detection of the syndrome is essential in full recovery. A serious late complication of rhabdomyolysis which occurs in 15% of the population is acute kidney injury, and in some cases it can lead to death.
Sources: en.wikipedia.org
== Kinases and health == Given the pervasiveness of kinases, it is unsurprising that mutations in genes coding for them cause many diseases. Myotonic muscular dystrophy, Hirschsprung's disease, craniosynostosis, and chronic myelomonocytic leukaemia are some of these diseases.
=== Physical === Most of the physical properties of astatine have been estimated (by interpolation or extrapolation), using theoretically or empirically derived methods. For example, halogens get darker with increasing atomic weight—fluorine is nearly colorless, chlorine is yellow-green, bromine is red-brown, and iodine is dark gray/violet. Astatine is sometimes described as probably being a black solid (assuming it follows this trend), or as having a metallic appearance (if it is a metalloid or a metal). Because it has a lower vapor pressure than iodine, astatine sublimes, as expected. Half of a given quantity of astatine will vaporize in approximately an hour if put on a clean glass surface at room temperature. The absorption spectrum of astatine in the middle ultraviolet region has lines at 224.401 and 216.225 nm, suggestive of 6p to 7s transitions. The structure of solid astatine is unknown. As an analog of iodine it may have an orthorhombic crystalline structure composed of diatomic astatine molecules, and be a semiconductor (with a band gap of 0.7 eV). Alternatively, if condensed astatine forms a metallic phase, as has been predicted, it may have a monatomic face-centered cubic structure; in this structure, it may well be a superconductor, like the similar high-pressure phase of iodine. Metallic astatine is expected to have a density of 8.91–8.95 g/cm3. Evidence for (or against) the existence of diatomic astatine (At2) is sparse and inconclusive.
=== Bioengineering === The subfield of bioengineering concentrates on creating novel metabolic and regulatory pathways, and is currently the one that likely draws the attention of most researchers and funding. It is primarily motivated by the desire to establish biotechnology as a legitimate engineering discipline. When referring to this area of synthetic biology, the word "bioengineering" should not be confused with "traditional genetic engineering", which involves introducing a single transgene into the intended organism. Bioengineers adapted synthetic biology to provide a substantially more integrated perspective on how to alter organisms or metabolic systems. A typical example of single-gene genetic engineering is the insertion of the human insulin gene into bacteria to create transgenic proteins. The creation of whole new signalling pathways, containing numerous genes and regulatory components (such as an oscillator circuit to initiate the periodic production of green fluorescent protein (GFP) in mammalian cells), is known as bioengineering as part of synthetic biology. By utilising simplified and abstracted metabolic and regulatory modules as well as other standardized parts that can be combined to create new pathways or creatures, bioengineering aims to create innovative biological systems. In addition to creating opportunities for novel applications, this strategy is anticipated to make bioengineering more predictable and controllable than traditional biotechnology.
Sources: en.wikipedia.org
It is a synthetic tetrapeptide built from alanine, glutamate, aspartate and glycine. The four residues are joined by standard peptide bonds, giving a linear chain rather than a branched structure.
The name derives from epithalamin, a pineal gland extract studied in the former Soviet Union. Researchers proposed that short fragments of that extract carried the biological activity of interest.
No major regulatory agency has approved it as a medicine. It is handled as a research chemical, and products sold under this name are not standardised drugs with defined clinical labelling.
Mass spectrometry provides the identity check, because the observed mass is compared with the theoretical mass of the AEDG sequence. Chromatography separates and quantifies impurities but does not by itself prove which peptide is present. The two techniques are normally used together.