The short version of tetrapeptide fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2026-04-27. Anything still debated is marked as such rather than presented as settled.
（TG:@pojiaai）Epitalon is a synthetic linear tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, abbreviated AEDG. It emerged from work on epithalamin, a peptide fraction prepared from bovine pineal tissue, and was designed as a short, chemically defined analogue of that extract. Early publications came mainly from Russian laboratories studying pineal peptides and aging-related endpoints. The compound appears in the literature under several spellings, including epithalon and epithalone, which complicates systematic searching. Its small size makes solid-phase assembly and routine analytical characterization straightforward.
Chemically, the molecule consists of four amino acid residues joined by three peptide bonds, with a free N-terminal amino group and a free C-terminal carboxyl group. Its molecular formula is C14H22N4O9, and its monoisotopic mass is approximately 390 daltons. The acidic glutamate and aspartate side chains give the peptide a net negative charge near neutral pH, a property that shapes its chromatographic behaviour and solubility profile. No disulfide bridges or other post-translational modifications are present, so the primary sequence alone defines the structure.
Reference material is normally supplied as a lyophilised powder in a sealed vial. Product literature typically recommends storage at minus twenty degrees Celsius or colder, protected from light and moisture. Freeze-thaw cycling is usually avoided because repeated condensation can introduce water into the vial. Working solutions are commonly prepared fresh, aliquoted, and kept cold for short periods rather than stored at ambient temperature. Labelling the date of opening helps track how long a vial has been in use.
Solubility is high in water, phosphate-buffered saline and normal saline, a pattern that follows from the two acidic residues in the chain. The peptide dissolves poorly in non-polar solvents such as hexane or chloroform. Stock solutions are often prepared in water first and then diluted into the buffer of interest. Because the molecule is small and hydrophilic, filtration through a low-protein-binding membrane is usually straightforward, and visible particulates are uncommon in freshly made solutions.
Identity and purity are established with reversed-phase high-performance liquid chromatography and mass spectrometry. The chromatogram shows the main peak and any truncated or oxidised by-products, while the mass spectrum confirms the expected 390 dalton mass. Amino acid analysis can corroborate composition when a sample's origin is uncertain. Counterion content, particularly residual trifluoroacetate from purification, is frequently reported alongside purity because it shifts the net mass of the solid.
| Property | Value | Notes |
|---|---|---|
| Chemical class | Linear tetrapeptide | Four residues joined by three peptide bonds |
| Sequence | Ala-Glu-Asp-Gly | Commonly abbreviated AEDG |
| Molecular formula | C14H22N4O9 | Free acid form |
| Monoisotopic mass | Approximately 390 Da | Matches values reported from mass spectrometry |
| Net charge near neutral pH | Negative | Contributed by glutamate and aspartate side chains |
Epitalon is a synthetic four-amino-acid peptide with the sequence alanine-glutamate-aspartate-glycine, commonly abbreviated AEDG. Its molecular formula is C14H22N4O9, and its calculated molar mass is approximately 390.35 grams per mole. The compound is a short fragment related to a peptide fraction isolated from bovine pineal gland extracts, and it is normally supplied as a lyophilised powder intended for laboratory research. It is not a registered pharmaceutical product in most countries.
The peptide emerged from research carried out in Saint Petersburg from the late 1980s onward, where investigators searched for shorter active fragments of a pineal preparation known as epithalamin. The name epitalon was chosen to reflect that parent extract. Early reports described effects on neuroendocrine markers and on the lifespan of laboratory animals. Much of that work appeared in Russian-language journals, with English translations following later, which affects how readily the original protocols can be assessed by outside groups.
Laboratory handling begins with dissolution of the lyophilized powder in water or a suitable aqueous buffer. The dry solid is the more stable form, so stock solutions are generally prepared only when required and kept cold afterwards. Repeated freezing and thawing of a solution is avoided because it encourages aggregation and gradual loss of the intact chain. Diluents and containers are selected to limit adsorption of a short peptide onto plastic surfaces and to reduce microbial growth in aqueous preparations.
Stability depends strongly on pH, temperature and the presence of oxygen and trace metals. Cleavage of the backbone proceeds faster under neutral to alkaline conditions, whereas acidic solutions tend to slow that reaction. The aspartate and glutamate side chains can undergo deamidation or imide formation over time, generating closely related impurities. Published stability data specific to epitalon are sparse, so the usable life of a given solution is best regarded as an open question that depends on buffer composition, concentration and storage temperature.
The four residues give epitalon a molecular formula of C14H22N4O9 and a molecular weight near 390.35 daltons. The presence of two acidic residues, glutamate and aspartate, makes the free peptide strongly acidic, while the alanine and glycine ends provide neutral, nonpolar character. This combination produces a molecule with substantial water solubility. Because there are no cysteine, methionine, or tryptophan residues, the peptide lacks the most common oxidation-sensitive side chains, which simplifies handling compared with many longer peptides.
The proposed relationship between epitalon and pineal function is a central part of its background. Khavinson's group reported that short peptides corresponding to regions of larger pineal proteins could influence gene expression in cells. Epitalon was framed as a synthetic analogue of an active fragment rather than a direct isolation product. Whether the tetrapeptide reproduces the effects of the parent extract is an open question, because comparative studies are limited and the parent extract itself is not a single defined substance.
Animal and clinical reports appear mainly in Russian-language journals from the 1990s and 2000s, covering endpoints such as melatonin rhythm, lifespan in aged rodents, and retinal function. Many of these papers involve small groups, lack blinding or placebo comparison, and are difficult to retrieve through indexed databases. Review articles published in English generally summarise the claims without reanalysing the underlying data. Because no large randomised trial exists, the clinical importance of these reported effects stays unresolved and is properly described as an open question.
No national medicines regulator has approved epitalon as a therapeutic product. It is generally distributed as a research chemical, and in some jurisdictions selling peptides for human consumption without approval is restricted or prohibited. Certificates of analysis accompanying commercial material vary in which tests are performed, and independent verification of identity and purity is uncommon. Statements about anti-ageing or disease-prevention benefits on vendor pages are marketing claims rather than regulatory findings, a distinction that shapes how the compound is discussed in scientific and popular sources alike.
== Applications and detection methods == FFF is applicable in the sub-micron range (from 1 nm to several microns) in the "normal" mode or up to 50 microns in the so-called steric mode. The transition from normal to steric mode takes place when diffusion becomes negligible at sizes above a micron. FFF is unique in its wide dynamic range of sizes covering both soluble macromolecules and particles or colloids which can be separated in one analysis. Typical applications are high molar mass polymers and polymer composites, nanoparticles, both industrial and environmental, viruses and virus like particles, lipid nanoparticles, extracellular vesicles and other types of biological samples. FFF can be coupled to all types of detectors known, from high-performance liquid chromatography (HPLC) to size-exclusion chromatography (SEC). Due to FFF's similarity to liquid chromatography (LC), a liquid mobile phase passing through the channel, the most common detectors are those that are also used for liquid chromatography. The most frequently used is an ultraviolet-visible spectroscopy (UV-VIS) detector, because of its non-destructive nature. Coupling with multi angle light scattering which allows the calculation of the size of eluting fractions and comparison to values obtained via FFF theory. Another popular detector is inductively coupled plasma mass spectrometry to characterize metallic nanoparticles with high specificity and sensitivity.
== Bibliography == Schiffman MA (2010). Autologous Fat Transfer: Art, Science, and Clinical Practice. Berlin, Heidelberg: Springer. ISBN 978-3-642-00472-8. Mary White Stewart MD (2012). Silicone Spills: Breast Implants on Trial. Santa Barbara, CA: Praeger. ISBN 978-0-275-96359-0.
=== Hematopoietic stem cell transplantation === Hematopoietic stem cell transplantation (HSCT) involves replacing the dysfunctional stem cells from a person with sickle cell disease with healthy cells from a well-matched donor. Finding a well matched donor is essential to the process' success. Different types of donors may be suitable, including umbilical cord blood, human leukocyte antigen (HLA) matched relatives, or HLA-matched donors who are not related to the person being treated. Risks associated with HSCT can include graft-versus-host disease, failure of the graft, and other toxicity related to the transplant.
Sources: en.wikipedia.org
=== Colloidal suspensions === Without sufficient attraction forces (e.g., Van der Waals force) to aggregate the solid particles together and to remove them from solution by gravity (settling), they remain in suspension and form colloids. Sedimentation can be accelerated by high speed centrifugation. The compact mass thus obtained is sometimes referred to as a 'pellet'.
=== Protein Purification === A significant application of synthetic biomolecular condensates is in the field of protein purification, offering an alternative to traditional methods like chromatography. The PandaPure technology leverages the principles of LLPS to isolate specific proteins of interest directly within host cells like E. coli. In one example, the researcher harnesses RNA-based TEARS system and co-express the target protein, which is autonomously captured and sorted into these synthetic organelles within the cell. After harvesting the cells, they are lysed to release the organelles, which now contain the concentrated target protein. Finally, in situ tag cleavage is mediated to release pure, tag-free protein from the organelle. This method simplifies the purification process into a single operation that includes tag removal, eliminating the need for columns, resins, or magnetic beads. It significantly reduces manual labor, time, and waste compared to conventional purification techniques.
=== Acetals and hemiacetals === Hemiacetals and acetals are essentially tetrahedral intermediates. They form when nucleophiles add to a carbonyl group, but unlike tetrahedral intermediates they can be very stable and used as protective groups in synthetic chemistry. A very well known reaction occurs when acetaldehyde is dissolved in methanol, producing a hemiacetal. Most hemiacetals are unstable with respect to their parent aldehydes and alcohols. For example, the equilibrium constant for reaction of acetaldehyde with simple alcohols is about 0.5, where the equilibrium constant is defined as K = [hemiacetal]/[aldehyde][alcohol]. Hemiacetals of ketones (sometimes called hemiketals) are even less stable than those of aldehydes. However, cyclic hemiacetals and hemiacetals bearing electron withdrawing groups are stable. Electron-withdrawing groups attached to the carbonyl atom shift the equilibrium constant toward the hemiacetal. They increase the polarization of the carbonyl group, which already has a positively polarized carbonyl carbon, and make it even more prone to attack by a nucleophile. The chart below shows the extent of hydration of some carbonyl compounds. Hexafluoroacetone is probably the most hydrated carbonyl compound possible. Formaldehyde reacts with water so readily because its substituents are very small- a purely steric effect.
Sources: en.wikipedia.org
It is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, often abbreviated AEDG. The molecule is linear and contains no modified residues, so it is fully described by its sequence.
The compound came out of work on epithalamin, a peptide preparation derived from pineal tissue, conducted largely in Russian laboratories. Later studies in other countries examined it mainly in cell cultures and animal models.
The tetrapeptide sequence is a synthetic construct rather than a described circulating peptide. It was derived by analogy to peptide fractions obtained from tissue extracts, not isolated from blood or tissue as such.
Sealed lyophilised powder is normally kept at minus twenty degrees Celsius or below, away from light and moisture. Vials are allowed to reach room temperature before opening to limit condensation. Repeated warming and cooling of the same vial is discouraged.